#Subaru coolant install
#Subaru coolant manual

The manifold along with the engine harness and fuel rail assembly will lift off the engine freely, exposing the coolant crossover pipe (the pipe running across the top of the block, says “subaru” on it) for easy access to remove and replace the seals.

#Subaru coolant manual

It would, however, be good to pick up a Factory Service Manual (FSM) familiarize yourself with the layout of the EJ engine–exterior block design, where you’ll be working, has not changed over 30 years of production–but you’ll have to first drain your coolant (quickest but messiest way is to pull the thermostat housing located at the end of the lower radiator hose), remove the air intake from the throttle body, then disconnect all the engine harness plugs, coolant & fuel lines, and unbolt the intake manifold. It’s a tedious, but simple task and certainly does not take 9 hours. Stealership is pulling your leg, as usual.

#Subaru coolant install

Next time I will drill and install safety wire instead of or in addition to locktite. That’s when you strip out the threads or break the thing. then I waited an hour or more to withdraw the bolts, apply locktite and reinstall, finally torqueing to ten foot pounds. Then put in the cleaned bolts, snugged down just to get the crossover pipe level and near the final position. Silicone upper surface, underside of crossover. Then I laid a bed of ultra grey and waited a bit, seated the new O-rings into it. I had to use an engraver to dig to the bottom of the pits, since they spanned the seat area. Must use additive in coolant, methinks, this is a high evaporative area, being above the engine and all and really prone to corrosive action from oxidation. PS the seats for these O-rings at the crossover pipe ends is very corroded on my 2003 unit. Nexus S 4G Return to Stock Google Firmware.Nexus S 4G Dialer Codes and Service Menus.Disable Nexus S 4G Camera Shutter Sound.Enabling SLI on a Dell Precision 690 with GeForce Video Cards.CDF Racing Clear Timing Cover Group Buy.XC60 T6 Powerflex Torque Rod Bushing Insert.